
Cable Clamping Plates
Product ID: 10515
Cable clamping plates with routing channels and a screw-fastened retainer for customer-defined cable positioning and restraint.
Product Description
The channels organize the cable route, and the retaining clamp applies the specified holding contact. Cable diameter, jacket material and tightening conditions must be considered together to achieve restraint without excessive compression. Entry and exit geometry should preserve the required bend radius and avoid sharp-edge contact. Pull-out and vibration behavior depend on the cable, clamp and mounting arrangement as a complete system. Application examples, subject to assembly design: a cable-entry retainer or a routing clamp plate inside an electrical or control module. The clamp should restrain the cable before pulling force reaches its termination. Cable tolerances and jacket softness influence the contact pressure produced by a given screw setting. Entry/exit support should be reviewed so that restraint does not create a short, highly stressed bend beside the clamp.
Product Features
Channels establish the specified cable routing. Screw-fastened retainer provides adjustable assembly contact. Mounting holes connect the plate to the equipment. Cable-contact radii and clamp gap matched to the jacket and diameter. Engineering focus: cable restraint without excessive jacket indentation or a sharp bend at the exit.
Technical Specifications
Indicative custom specification for RFQ; final drawing and quotation govern. Materials: 6061-T6 aluminium plate; 304 stainless plate option. Cable-contact inserts/cushions are separately specified if needed. Tolerances: General metal sizes ISO 2768-1-m; proposed channel profiles +/-0.10 mm, clamp-gap features +/-0.05 mm and fixing-hole position 0.10 mm. Surface treatment / roughness: Aluminium anodizing 10-15 um or stainless brushing/passivation; cable-contact edges rounded/deburred; face texture per jacket-contact design. Indicative size range: Plate length 30-160 mm; width 20-100 mm; thickness 3-15 mm; candidate cable OD 3-20 mm after clamp/jacket validation. Proposed process: CNC milling / channel machining / drilling/tapping / contact-edge finishing / treatment / retainer assembly and retention checks. MOQ: Reference lot 50 pcs per part number; final MOQ per quotation. Target lead time: Target 2-3 weeks (10-15 working days) after drawing/material/order approval; final quotation governs. Reference standards: ASTM B209/B209M; ASTM A240/A240M; ISO 1101:2017; ISO 965-1:2026; ISO 7599:2018; ASTM A967/A967M; apply only to the selected material/process and scope. Note: Cable OD is a design selection range, not a certified pull-out rating; permitted jacket compression and torque require validation. Size-range limits are not all combinable. Surface/heat treatments are project-managed through qualified partners where required.
Related products
More from Low- & Medium-Voltage Electrical Parts

Circuit Board Cover Plates
Circuit board cover plates with machined pockets, opening arrays and perimeter fixing features for customer-designed electronic assemblies.
View Details
Wire Harness Protection Plates
Formed wire harness protection plates with clip locations and mounting features for organized routing within customer equipment.
View Details
Non-Metal Spacer Sleeves
Non-metal spacer sleeves with a central bore and flat end faces for drawing-defined separation and positioning between components.
View Details